Francois St-Germain wrote:

Hi group Does somebody here has already work on the
water pump to reduce is volume it is too big too fit
I need a smaller pump housing!
Thanks
Francois

Yes I guess it would be for a one rotor. I don't know of a smaller
one that could be adapted to a one rotor but I am sure there is
one out there somewhere.

Paul Lamar

   Francois,
     I have seen a Ford Fiesta (1979 to 1980+ model)
 water pump adapted to 12A rotary. I do not have the
 details but it required an adapter block (aluminum)
 between the pump and engine. I have a photo of this
 installation somewhere. Will try to find it and post.
     This pump worked but I can not tell you flow rate,
 etc. I acquired one of these pumps with the intent of
 installing on a 12A several years ago. The pump is very
 compact and light (aluminum housing).

     Kelly Troyer

Dyke Delta/13B Rotary Power

bill martin wrote:

Bill Martin wrote:
     I have this Ford pump and adapter that came with a bunch of stuff
that was made by our famous friend Duncan.The adaptor is quite nicely made
and the pump is quite light.It was originally intended to be used by
Duncan on the 13-b.After looking at for about 2 minutes,I decided to use
the Mazda pump.I still have both and would easily part with them.You can
write me directly at --bill@laguna.com.mx

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org