| Subject: Perry's rotor housings. |
| From: ACRE NL |
| Date: 5/9/2001, 2:49 PM |
The rotor housing were not shrunk. Measured them in several places and it all came out to 3.148 3.149 which is right at 80 mm.
marc wiese wrote:
It has also been my experience that it takes A LOT of heat to shrink and warp these housings! If they are not worn excessively or chipped, then chances are they are ok.
The AirCraft Rotary Engine NewsLetter. Powered by Linux. http://home.earthlink.net/~rotaryeng/ http://www.linux.org