Mark. On the subject of tension bolts you might also mention the need to
coat them with RTV before installation. If your engine is already built
take the bolts out one at a time, coat them with RTV and replace and
torque them before you remove the next one. Do this in the order
shown in the shop manual.
Paul Lamar
Lonnie Wood wrote:
Paul,
Could you clarify this for me? Is the RTV to go on the threads or is
it to coat the whole shaft of the tension bolt? Is the RTV allowed to
cure before installing the bolts?
Lonnie
Goes all over the shank of the bolts. The idea is to fill the clearance holes
with silicone rubber to damp the violin string type vibrations.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org