Leon Promet wrote:
G'Day Paul,
The best stuff to use would be the Silicone Grease in a spray can that can
be obtained from most electrical trade supply outlets. I have used it for
putting plug boots on plug leads when making custom ignition harnesses,
and routinely as well on all sorts of O rings where lubrication is
necessary for assembly. An apex seal spring or a small screwdriver,
especially dressed and smoothed for the purpose (similar in PRINCIPLE {but
not shape} to a tyre bead tool on a tyre changing machine) is then used to
ease the O rings in the groove. The trick is to cock the Scraper ring
SLIGHTLY to get a start. The special screwdriver end is then used to ease
the O ring into the groove.
If anyone inadvertently does happen to install an oil scraper ring without
the spring, or needs to remove a particularly obdurate old one, there IS
a way of getting then out. Simply drill a very fine hole using a number
drill or carb jet drill to intersect the O ring groove below the O ring.
Even if installed without a spring, there is a space below the scraper
ring.
Compressed air will then pop it out. The hole is then closed with Loctite
and a small Allen Head grub screw and staked so that it can't back out.
Works like a charm, ... you just have to be REAL careful and get the angle
correct. I practiced on a couple of busted rotors first until I got it
right. Saves breaking expensive scraper rings!!
Stupid Question of the day:. Do you know of anyone who has ACTUALLY used
these O rings and has actually run them in engine for an extended period
(years)?? If so, who, and what were/are the results of longevity?
Cheers,
Leon Promet
Thanks for the O-ring installation tips Leon.
No Leon. That is why we call them experimental airplanes :-)
It is all theory based on the superior temp and chemical resistance
capabilities of Teflon.
We are pushing the rotary engine envelope here. No car engine runs
150 HP continuously.
Jerry Bass is seeing 260 degree F oil temperatures as we speak.
Probably as the result of inadequate air ducting but these things
happen as each different air craft installation is different.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org