Paul wrote>
Mazda or we could make the rotary much more tolerant to temporary
overheating with a simple addition of a special seal.
This seal consists of a small strip of stainless steel 1/4 inch high
inserted into slots in the rotor housing and side housings. This
would shield the Teflon Encapsulated Silicon O-rings from the
hot combustion gases in the event the engine was overheated
so bad the rotor housing shrank.
This type of seal is called a labyrinth seal. It is not
a true seal in the sense that gases cannot get by it.
Mark Wrathall wrote>
These leaf seals (labyrinth seals are normally multiply knife edges which
cut there own groove in a honeycomb seal surface) are used everywhere in the
nozzle guide vanes of turbine engines. If a rotary is built to spec, the
primary seal is the metal contact of the housings. The o-ring is likely
there to prevent seepage and static leaks right? When a failure occurs like
the tension bolt breaking, then the o-ring is asked to do a job it is not
capable of. Your leaf seal idea would then help. It could be made of thin
spring steel and welded on a bandsaw blade welder.
I don't think it would have to go all the way around the housing. Just about
90 degrees or so adjacent to the hot side of the engine.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org