1) One thing I quickly noticed when tearing down my 20B is that there is not
an eccentric shaft thermo pellet in the flywheel end of the e-shaft.  Does
anyone know if this means that it was already bypassed on the 20B like we
commonly do on the 13B?  Or, is there another system that should be bypassed
on the 20B???  I've attached a picture of the end of my e-shaft without the
thermo pellet.

2)  On the Turrentine video he shows removing the check balls in the oil jets
and installing carb just instead.  Has anyone done this, and if so, where can
you buy the jets?

3)  Does any know when the Turrentine 20B video will be available??

Thanks,
Don

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org