Subject: Oil control Teflon O-rings on the rotor sides.
From: ACRE NL
Date: 5/12/2001, 7:41 AM


BruceTurrentine@aol.com wrote:

Try just lubing them up (O-ring and Groove) with petroleum jelly, then use a
3/4" piece of particle board to press them directly in. I have had to resort
to this using the Viton O-rings, because they are much stiffer that the stock
Mazda parts. Just make sure you don't have any burrs along the top of the
groove. I have chamfered some rotors with a dremmel and stone. It really
makes a difference.

    Bruce,
      Have you identified size and part numbers for Viton
 and/or Teflon "O" rings (oil control)?At last report on
 this group only the outer oil control  "O" ring had been found.

   Kelly Troyer

--
Dyke Delta/13B Rotary Power


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org