Subject: Oil control Teflon O-rings on the side of the rotor.
From: ACRE NL
Date: 5/12/2001, 7:16 AM


Hans Conser wrote:

I noticed on the engine that I just put together that the new factory oil
o rings were both green, instead one green and one black like they used to
be.

Hans

Stick a set in the oven Hans and cook them at 500 F. Open the windows as
the smell may be toxic :-)

Paul Lamar


Paul,
What's the purpose of this??
Don

This is our standard temperature test for engine oil. Even though the overall 
temperature of the oil is only 250 degrees F or so local temperatures of the metal 
it can come in contact with can be much much higher. This is what causes the coking
on the rotor housing surface. This is true for any engine. The failure mode for
these oil control O-rings is melting when the engine is temporarily over heated 
for any of a number of reasons. If you melt your oil control O-rings the engine 
will smoke badly when started up. It will also probably consume more oil and 
coke up the side seals perhaps causing them to stick. These are best lubed 
with two cycle oil that burns cleanly and does not coke on the surface of hot metal. 

The TES O-rings are cheap insurance against this happening as they can tolerate
500 degrees F. To fix melted O-rings you need to disassemble the engine of course.

BTW Perry wanted me to mention how clean his rotors looked. They were much 
cleaner than any 120,000 mile or more engine I have seen so far. This, we think
is due, to the disabling of the EGR as Perry is still injecting crankcase
oil into his engine to lube the apex seals. We think most of the crude that was on 
the rotors in its life as a car engine was burned off after he disabled 
the EGR. Perhaps it was burned off when the engine was overheated.

I might also add that there was a considerable amount of coking 
on the rotor housings. We are not sure when this occurred. It could have 
occurred when the engine was used in a car or it could have occurred when 
we repeatedly over heated the engine in Palm Springs test flights. It 
is well known in car racing that this does not occur when two cycle oil 
is mixed with the gas. 

Our own test with two cycle oil at 500 degrees F
bears this out. Paul Yaw was able to test it on a metal plate
by heating the back side with a torch. The two cycle oil disappeared 
completely unlike motor oil. No residue of any kind. This is a simple test that
anyone can perform confirming these results.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org