Paul,
I think that if I ever overheat my engine to the extent that you are speaking
of, I will want to tear the engine down and inspect it anyway. Especially as
easy as this engine is to work on!!! Having said this, I keep wondering why
the original O-ring won't provide adequate service? As it stands now, I need
to assemble my engine but there are no adequate TES inner oil control O-ring
or outer coolant O-ring. I think I will try again to install the outer TES
oil control O-ring and then use the outer TES Coolant O-ring. Then I will
install the original O-ring in the other positions. We'll see what happens I
guess!!!
Thanks again,
Don
"tear the engine down and inspect it"
It is easy to say this but think how hard it would be 700 miles from home
like the experience Perry had. This can get very expensive what with hotel bills
and flying back and fourth on commercial flights. Rotaries in airplanes are
a whole new world and the infrastructure for repairing your rotary aircraft engine
away from home is just not out there yet. Perry is very lucky it happened
125 miles from my house so it was possible for me to help him remove the
engine. As it was it took Perry about 3 hours to get the engine out.
It then took us two hours to drive to my hangar where we could take the
engine apart not to mention the couple of days we used trying to trouble
shoot the problem. It could have happened another 100 miles out in the boonies
and that would be much worse.
Tracy was lucky on his trip to AZ because it was the muffler he had problems
with. Those can be fixed almost anywhere.
Given that scenario TES O-rings everywhere are just another thing making
the engine more tolerant of temporary overheating.
True the oil O-rings are less critical than the water cooling O-rings.
Hang on a few Don. The right O-rings exist. See this list from Creavey the Manufacturer.
I will call them Monday and see if I can get the exact right size with Ken's
Powell's help.
Ken please look at the list and pick the size you think is closest. We will
get enough for Don as he is putting his engine together now.
In the meantime Don fashion a ring compressor using large hose clamps thin
sheet metal and old Mazda cast iron oil scraper rings. Probably a regular piston
ring compressor would work using old Mazda cast iron oil scraper rings
to stabilize the top part. Take Bruce's advise and slightly chamfer the edge
of the rotor slot where the O-rings are inserted.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org