Subject: Oil control Teflon O-rings on the side of the rotor.
From: ACRE NL
Date: 5/12/2001, 2:49 PM

I just had another idea Don.
Since Teflon cold flows insert the O-ring in the cast iron
scraper ring. Wrap it with some real thin sheet metal. 
Say .010 stainless and use a large hose clamp to compress the TES
O-ring. 

Or a bunch can be done in a large piston ring compressor.
Let them  sit for a few days and the scraper rings with the 
O-rings in them should then drop right down in the rotor grooves.
The Teflon will recover with a bit of heat and pressure from
the silicon rubber core.

That should work on the inner ring. The outer ring is a bit harder
but if you have a lathe a cylinder can be machined from aluminum or
steel pipe just the right size with a slight taper to push all the outer 
scraper rings down over it and cold flow the teflon slightly. Allow to sit
for a few days, remove the scraper ring with the TES in it and install.

I am testing more or less the same trick on the coolant O-rings
right at the moment.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org