While we are on the subject of oil routing, I'd like to get some input on
plumbing oil lines.  I have a 20B while normally has a front cover with two
oil fittings.  I changed the front cover to what I think is a 12 series cover
(but I'm not sure because Atkins sent it to me to work with his motor mounts
and didn't say what it was.)  This new cover only has one oil fitting.  I
will need to plumb for an oil cooler at the nose of my Velocity and for
Tracy's Redrive.  Can anyone discuss the oil route through the engine and
make any suggestions on doing this plumbing properly??

Thanks,
Don

Here is a 13B diagram Don. I don't have one for the 20B.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org