Subject: Water cooling reliability & PSRU pressure
From: ACRE NL
Date: 5/16/2001, 11:51 AM


"Bass, Jerry" wrote:

Hi again.  Thanks for the info about my Oil Cooler. Tracy also said that
his
lies flat.  I can change the shape of my cooler duct and remove the air
guides.  The oil cooler air flows upward directly onto the oil pan.

I also found the gear set for the Ross drive may act as an oil pump
which
pressurizes the oil seal.  I added a small drain under the oil seal .
The
oil has no way to get back to the reservoir.  I drilled a hole in the
bell
housing in order to get the tube, from the bell face back outside the
housing. It will go to the pan.

I also found that I put he .030" washer next to the gear and I intended
to
put the .060 washer there.  Ross has chamfered his .060 washer to get
away
from the radius between the gear/shaft intersection.  I will revise my
thrust bearing and put a .060 washer near the gear with relief for the
radius.

Jerry Bass

Lying flat is not a problem if the duct is correct.
Don't forget to shield that exhaust pipe from the oil cooler Jerry.

Paul Lamar


Jerry,
    I found the same effect of gears apparently causing some pumping action
which pressurizes the oil seal.  I added a 1/8" dia hole at the very top
rear part of the gear casing (near rear oil seal).  I found that up to 5000
rpm nothing happens, after 5000 rpm approx 10% of the total oil flown into
the gear box comes out the 1/8" vent hole on top of the gear box.  So, I did
the natural thing and vented it back to the oil sump.  I have had no oil
leaks since then with over 20 hours of engine run time. Don't understand
what is causing it other than some pumping action of the gears.  I tried
different size restrictors in the oil feed line and while it did affect the
total oil flow through the gear box, 10% of the total flow came out the top
after 5000 rpm.

Ed Anderson

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org