Don't recall the shiny limit spec on the oil control ring, but it's 0.045" or so in width.. More wear than that and the oil ring quits scraping the oil off and starts riding up on the oil film. That's
when smoking commences. How about some ideas on improving this area. I've torn down more than one engine that probably would have gone another 100,000 miles if the oil control rings didn't have this
wear on the tapered face of the ring.
Roger Robertson
Try Mobil 1 or some other true synthetic in the crankcase. My test indicates it is somewhat
better at high temp (500 F) than regular motor oil. Less oil breakdown at high temps.
Paul Lamar
John McLaughlin wrote:
Mazda sells Competition Oil Control Ring Springs for the front and rear outer rings [pn 4352-11-3530 front & 4352-11-3630 rear]. Used with the Mobil One it might be a nice upgrade. They cost $1.24 extra from Mazdatrix.
John McLaughlin
If the spring pressure is greater I am not sure that is a good idea.
That could lead to higher side housing wear. Competition engines
have a very short life compared to an aircraft engine. Even if they
are raced for two years without overhaul that is still probably less than
200 hours running time. On the other hand the spring pressure could be less
for less friction. In that case go for it :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org