Rob Weinstock wrote:
What do you mean by "oversized" Rob?
Both the rotor and main bearings are available in a standard clearance or an
oversized clearance. The oversized bearings are designed to provide a
bearing clearance of 0.003", slightly less than the maximum 0.0039"
specified by Mazda. This will vary somewhat depending on the tolerances of
the rotor ID (where the bearing is pressed into) and the eccentric shaft
rotor journal OD.
The idea is to provide a thicker layer of oil for the rotor to ride on,
reducing friction and metal to metal contact, as shown in the posted photo.
You can also use the 1993-1995 Mazda RX-7 bearings. These have a better oil
grove and come in several different clearances, allowing the engine builder
to really blueprint the engine. These will press in fine, but something will
have to be done to pin the bearing to prevent it from spinning.
Regards,
Rob
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org