Subject: Oil dsitribution and rotor housing wear
From: ACRE NL
Date: 5/19/2001, 7:44 PM


Wrathall Mark wrote:

Paul, I misplaced the photo you posted a couple months ago showing the
rotor
housing wear pattern downstream on the oil injection port. Could you
please
repost it.I would like to use this to illustrate the page on oil
distribution I posted last night.

Mark Wrathall
www.rotary.microcosman.com


Sure. BTW I noticed a similar pattern in Perry Mick's engine.
Not quite so bad. Perry had installed new plastic injector lines.
I think we really need to mix two cycle oil with the fuel
for even distribution.

Paul Lamar


Paul,
I noticed that Hayes does an oil Metering System Modification.  He states in
his catalogue that:

"an enlarged oil metering inlet is available for all 1984+  13B engines.
For High performance and racing applications Hayes Rotary recommends a
special oil metering system modification.  This modification installs four
oil metering inlets on the rotor housing intake side stretching across the
entire housing.  It will reduce friction and will give any apex seal the best
protection available under severe racing conditions."

1)  Do you know what he means by "an enlarged oil metering inlet is available
for all 1984+  13B engines"?  To me, this sounds that he is saying that its
something   readily available and not part or his more extensive
modification.

2)  What do you think of his modification idea and have you heard of anyone
using it?  I have been considering the addition of an oil metering pump
adapter connected to a 2-cycle oil tank.  Would the addition of 12 more oil
metering inlets effect the oil delivery ratio or just spread the same amount
of 2-cycle oil out more evenly over the apex seal?  Do you think its really
going to reduce the Apex Seal chatter along the trochoil surface?  Do you
think its necessary in our RPM range or if running in a normally aspirated
environment??

3)  Do you still consider mixing 2-cycle oil as a better alternative sending
it through a metering pump?  I have heard such different opinions on this
that I'm still confused about it.  When I talked to Atkins last month,  he is
a strong advocate of the original oil metering pump injection of crankcase
oil.

Don Mitchell
Velocity / 20B

As I recall  Dennis Hayes mentioned this when I was up there. I think he adds
some oil injection jets in the rotor housing on each side of the stock one
that is already there. Seems like an expensive way to solve the problem.
Just mix one ounce of two cycle oil with each gallon of fuel. Problem over.

It really escapes me why Dave Atkins has that opinion. Obviously he has
never heated motor oil in an oven to 500 degrees F. Here is a chart from the
Mazda book "Rotary Engine" by Kenichi Yamamoto showing the temperature 
of the apex seal. I suspect Dave has not seen or read this book or he would 
understand why two cycle oil is necessary. Dennis Hayes seems to be much better 
informed on the workings of the rotary engine from an engineering point of view. 
The guys at Mazdatrix are pretty knowledgeably too... not to mention Racing
Beat the real pioneers.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

apexOIL2.GIF

sealtemp.gif