Subject: Preflight check for cooling system leaks.
From: ACRE NL
Date: 5/21/2001, 6:47 AM


 I think you have that backwards Bill. Lets look at this in terms of
 numbers. Lets say the total cooling system is one cubic foot. Lets say
 our airspace is one cubic inch pressurized to 30 psi. Lets say we lose
 a half cubic inch coolant to the internal leak in five minutes. We
 then have an airspace 1.5 cubic inches with the same number of air
 molecules. I would expect the pressure would then be 20 psi. Don't
 forget, we turn off the pump when it reaches 30 psi and watch the
 gage.

In our case there was a dramatic loss of pressure right away.
Far more dramatic then when starting the cold engine and watching the gage.
It takes time for the coolant system pressure to build up when
you start a cold engine. It may not get above 5 or 10 psi until
you actually take off and climb out.

Nothing new about this technique as radiator shops use this technology
all the time to check for coolant system leaks. Perry and I first
shopped for one of these radiator shop tools in Pep Boys with no luck
so I decided to build the tubeless tire valve adapter and use the
pressure gage that Perry had already installed on the instrument panel.
I already had the emergency tire inflator compressor in the Carvan.

Paul Lamar


If the system is totally liquid filled, with no trapped gas, then your
analysis is correct

Bill Schertz
KIS Cruiser #4045

What am I missing Bill? Why? I mentioned starting with one cubic inch of trapped gas.
Do you mean dissolved gases? If so does the dissolved gases escape from
the liquid when it is pressurizes to 30 psi? 

OK Bill it just dawned on me. Good point.

Yes. I assumed the system was properly vented and filled. If there is a 
large air pocket in the top of the block then it could take awhile for 
the pressure to fall off.

Actually any rubber hoses in the system also enter into the results.
The hoses will expand slightly when pressurized to 30 psi increasing 
the over all air volume.

I forgot to mention something else we also learned with Perry's cooling
system. If you have a nose (pusher) or tail dragger you are unlikely to fill
the engine without trapping air unless you vent the rear (in the car) end housing
or raise the nose or tail until the engine becomes level or the 
water inlet to the block passage becomes higher than the rear end housing. 
The water inlet passage to the block is located right behind the water pump
between the front end housing and the water pump.

That is because the water inlet to the block is lower in tie down attitude 
so there could be a large air pocket in the top of the block. It is a good 
idea to put several strategically placed  vent valves  in 
the system and open them when filling the system. Vent lines from the
rear end housing would also work.... connected back at the filler necks.
The vent lines are a better idea because the rear end housing could trap
vapor in a high angle climb attitude.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org