marc wiese wrote:
Hello Rotary Performance Gurus:
I am planning to use a 1986 13B Fuel Injected in a carbon fiber composite kit
plane. So far I have found info on using aftermarket teflon O-rings, good to
500 degrees, over the stock O-rings, which melt at 200 degrees. This motor
will be run constantly between 5800-6500 RPM range. I will be wanting to run
under driven pulleys, and doing a racing port & polish job for the 5800-6500
RPM range. I need to lighten this motor as much as possible, No AC, PS, smog
pumps, etc. I would like any recommendations of light weight, aftermarket
racing parts, for this motor. Also any durabilty modifications, parts, you
would reccommend. I would like to replace the stock fuel injection and
exhaust manifold with something lighter and smaller. If you wish to e-mail me
direct, send to Armilite@aol.com. For now I'm trying to keep this as simple
as I can, no turbos. Thanks.
Rich Gillen
Need recommendations for these after market racing parts:
Alternator
Water Pump
Oil Pump
Ignition
Exhaust Manifold(stainless)
Fuel Injection
Under Driven Pulley System
Fuel Pump
etc, etc.
He is on here Marc.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org