Ian & Irene Beadle wrote:
The RV6A has about 24sq" each side as standard. My air cond rads are
9"x10"X2.5" close to, and parallel to the openings.Cooling did not
work
until I added outlet slots on either side of the cowling in the low
pressure
area. Inlet to the oil cooler is only 3" diameter and is OK for level
flight. More test flying soon, I'm still a bit nervous after having
the
front leg collapse.
Any more news on the noise abatement? Mine has got to be fixed before
I go
deaf!
Ian Beadle.
Mike Wills wrote:
Ian,
3" diameter for the oil cooler inlet seems pretty marginal to me. It
appears that 20 to 30 square inches seems to be the norm for most of the
flying installations. 3" diameter is only 7 square inches. I'm surprised
it
cools at all. Are you using the stock RX7 cooler? What are your ambient
temps where you are located? And what do you see for oil temp in climb?
Mike Wills
"Bass, Jerry" wrote:
To answer Mike Wills, I had about 224 F oil temp at climb. I am using a
stock Mazda oil cooler with the bypass blocked. the oat showed about 35F
last December, and one day it was 95F this spring. I have now increased the
oil air inlet to about 20 sq.in. I have also increased the Water Air inlet
to 7" dia. each side.
Not yet tested these new changes, however.
Jerry Bass
I think the question was for Ian Jerry but thanks for the info.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org