McMaster Carr cat 105 page 3043 .380 ID, 1.125 OD, load 1220
pounds,
.078 thickness. They have others with a larger hole about the same
rating. You will need three or four making the bolt about a 1/4
inch
longer.
Paul Lamar
At McMaster.com I found 18-8 stainless spring washers, 10.5 mm I.D.,
23mm
O.D.
and 2.54 thick. They do not give a load rating but they are the same
thickness
as the heavy duty Belleville at about 5000 lbs. They are reasonably
priced
at $11 for
25. Does anybody know if McMaster has a minimum order?
At this point I am thinking of using 4 washers, 2 in parallel and 2
in
series. I will put
them together on some scrap wood to test the compression of the
springs in
relation
to the compression of the wood at various torque settings.
McMaster does not have hardened washers in large enough O.D. to put
under
these.
Found some at Earnestmachine.com, 100 for $6.48.
Lonnie Wood.
Lonnie,
What size (thread) bolts are you using on your prop?
Bill Freeman
They are 3/8 by 24 tpi. I will have to get longer bolts to hold all
of these washers. The Belleville washers need about .5 mm play
on the bolt, seems they neck down when compressed.
I carved the prop about 3 years ago, still need to get set up for
drilling the bolt holes.
Lonnie Wood
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org