Scott Speirer wrote:

Thought I'd write to let the readership know I finally received the redrive I had
ordered from Ross Aero out of Tucson, AZ.  It is a new 2.85:1 drive.   This drive has
a number of thrust washers and thrust bearings installed on the input shaft in an
area of the shaft in between the bell housing and the sun gear.  (I think it's called
the sun gear.)  The flat center area of the bell housing is supposedly thicker than
in earlier castings.  I think there are also supposed to be thrust bearings and
washers at both ends of the prop shaft inside the cone assembly.  (Don't know if
'cone' is the right word for it.)

I've taken some pictures with my old Nikkormat camera, and should have the
Kodak-developed photos-on-CD back tomorrow or Friday.  I'll then send a few of them
to this newsletter in an e-mail.  This drive looks pretty good, but I'm not a
machinist or drive expert, by any means, and so I'm hoping that many of you will look
at the pictures and give me your humble, educated opinions of it.

Unfortunately, I was very unhappy with the treatment I received from Ross Aero.  I
have filed a complaint with the Southern Arizona Better Business Bureau.  I hope that
Chris Ross will improve his business practices in the future.  I'll provide the
contents of my BBB complaint in a separate post to this newsletter.

Scott

Seems you're not the only one. See the May 2001 issue of SportAviation page 129, lower
right.

Finn

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org