Subject: Belleville washers for prop bolts
From: ACRE NL
Date: 6/1/2001, 3:18 PM


McMaster Carr cat 105 page 3043  .380 ID, 1.125 OD, load 1220 pounds,
.078 thickness.  They have others with a larger hole about the same
rating. You will need three or four making the bolt about a 1/4 inch
longer.

Paul Lamar

At McMaster.com I found 18-8 stainless spring washers, 10.5 mm I.D., 23mm
O.D.
and 2.54 thick. They do not give a load rating but they are the same
thickness
as the heavy duty Belleville at about 5000 lbs. They are reasonably priced
at $11 for
25. Does anybody know if McMaster has a minimum order?

At this point I am thinking of using 4 washers, 2 in parallel and 2 in
series. I will put
them together on some scrap wood to test the compression of the springs in
relation
to the compression of the wood at various torque settings.

McMaster does not have hardened washers in large enough O.D. to put under
these.
Found some at Earnestmachine.com, 100 for $6.48.
Lonnie Wood.

Charlie and Tupper England wrote:

Lonnie,

Belleville or not, it's not a good idea to run a wood prop
without a crush plate between the bolt heads & the prop. The
crush plate spreads the pressure over the entire diameter of
the prop hub, instead of just 6 1" dia circles. No crush
plate is begging for a prop failure. You can still try the
bellevilles outside the crush plate.

That said, I will tell you that I live it the deep South
where humidity varies from 30% to 100% & temps from near 0
to well over 100 & I've never had a problem with prop bolts
loosening after proper installation.

FWIW,

Charlie

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org