Subject: Belleville washers for prop bolts
From: ACRE NL
Date: 6/1/2001, 4:12 PM


Charlie and Tupper England wrote:

Lonnie,

Belleville or not, it's not a good idea to run a wood prop
without a crush plate between the bolt heads & the prop. The
crush plate spreads the pressure over the entire diameter of
the prop hub, instead of just 6 1" dia circles. No crush
plate is begging for a prop failure. You can still try the
bellevilles outside the crush plate.

That said, I will tell you that I live it the deep South
where humidity varies from 30% to 100% & temps from near 0
to well over 100 & I've never had a problem with prop bolts
loosening after proper installation.

FWIW,

Charlie

Absolutely correct about the crush plate.  Since they are aluminum
in all the cases that I have seen, I suggested hard steel washers to
keep the edge of the belleville washer from gouging into the aluminum.
I thought this was understood, but apparently not.  Thanks for the
clarification, we are about communication and if it is not clear to
everyone, we need to comment and clarify, like this.

As to the 30-100% humidity, I agree.   The issue is (apparently)
going from this (normal, in view) environment to a very low humidity
(desert) like 5% RH and apparently losing the preload.  I cannot
personally verify that humidity related shrinkage is the cause of losing
the bolt tension, but I can absolutely verify that if the tension is lost,
the bolts will break soon thereafter.  This humidity related prop loss
issue was dealt with extensively in the Canard Pusher (RAF newsletter)
in the 80s and later.  Dick Rutan had a propless IFR landing once for
this reason, more fun than I need.

Bill Freeman

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org