Subject: Rapco dry air pump
From: ACRE NL
Date: 6/1/2001, 7:07 AM


 >>Is that an aircraft vacuum pump you are driving off the back of
 >>the alternator?
 >>
 >>Paul Lamar

snips...

Yup, that's a Rapco dry air pump.  I've had enough piddling with oil
separators to last a lifetime!  Threw in the towel and went with a dry
pump.  Frustrating, since the wet pump worked beautifully -- I''m just
running out of experimentation time with the oil sep.  Probably go back to
it aftert Osh.

snips...

-GR

Cozy N722 -- Mazda 13B
Turbo  http://bluemtn.com/greg  -or-  http://bluemountainavionics.com

Does that A/C pump run at alternator speed Greg or is there a gear box in there?
Do you need to buy the alternator from them or can you adapt it
to any alternator? That would solve some problems for me as I have no
room for a smog pump (used as a vacuum pump). Lighter weight too.

Kind of a brilliant idea as the alternator bearings replace a bearing
adaptor that one would have to make if one were driving and aircraft
pump with a v-belt.

Here is are a few interesting old messages on the subject in no particular
order.

Subject:       alternator/vacuum pump combined
   Date:        Fri, 10 Mar 2000 16:46:24 -0800

Barry Gardner wrote:

I had a combined alternator/vacuum pump on a 83 Nissan Sentra
diesel that I owned. It worked but my recollection was that it
was heavy. I imagine that all diesel cars would be donor
candidates for this kind of combined unit. People should research
VW Golf/Jetta and Mercedes Benz units, as they had the greatest
numbers of diesels in their running product line, I think.

Barry Gardner
Wheaton, IL


Subject:       alternator/vacuum pump combined
   Date:        Fri, 10 Mar 2000 07:32:47 -0800
  

Mike Pienaar wrote:

Some of the guys here that are installing auto conversions mentioned using
an Isuzu (same as GM ) truck alternator that has an integral  vacuum pump
attached to the rear of the unit. It is evidently used on the turbo diesel
models to supply vacuum to the brakes. I don't know if anybody has succeeded
but it should reduce complexity.

Mike

Subject:        Vacuum system... an elegant solution
   Date:        Thu, 03 Aug 2000 17:10:46 -0700

Howard wrote:

I have seen alternators on diesel engines that have a vacuum pump attached
directly to the back..... The one that comes to mind is the alternator for a
Pugeot 504 diesel.   This vacuum pump is intended to supply vacuum for
brakes and I suspect also heater controls.  It is quite small and
light....the combination charging and vacuum system would be an elegant
solution.
                                                 H.W.

Subject:        Lucas - TVS - Products - Alternator with vacuum pump.htm
   Date:        Fri, 04 Aug 2000 06:50:45 -0700

Ed Anderson wrote:

Paul,
    Here is an example of the alternator/vacuum pump arrangement that some folks
have mentioned.  Looks like it is good to 11,500 rpm according to the specs.  Seems
strange to be rated that high in rpm.

http://lucas-tvs.com/products/3ha.html
.

Ed

                            Alternator with vacuum pump
                                    3HA 15 - 40

                                      
           RATINGS:
           System voltage             :  12 Volts
           Polarity                   :  Normally negative earth
           Rotation                   :  clockwise (viewed on drive end)
           Maximum speed              :  11500 rpm
           Operating temperature      :  -30°C to 100°C
           range
           Maximum output (hot)       :  40 amps nominal
           Regulating voltage         :  14.2V ± 0.3V
           Approximate weight(without :  5.3 kg
           pulley)
           Pump capacity              :  30 cc (per revolution)
           Maximum vacuum             :  700 mm Hg at 5000 rpm
           Requirement                :  Engine oil lubrication oil
                                         pressure 3 kg/cm² at 5000 rpm.
                                         Oil quantity-0.4 litre /minute
                                         at 5000 rpm

           FEATURES:
           Fixing                     :  Double lug mounting with a
                                         sliding bush for proper
                                         tightening. Additional lug for
                                         belt tensioning.
           Terminations               :  Steel terminal for positive
                                         connection. Lucar terminal for
                                         warning lamp and phase tap
                                         connection.


 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

enginetop052501.jpg

alternator-vacume-pump-combo.gif