mike h wrote:
> 1. Front cover:the mounting holes have been removed because of a crank
> angle sensor change
Went from distributor type CAS to directly mounted on the Eshaft front pully
assembly.
> 2. Side housing: the side housing is thinner for decreased weight, and
> the intake port has been enlarged to match the turbocharger.
I think the casting is thinner; the ones I have seen are the same (or very,
very close) to the 13BT housings. I'd like to see some definite measurements
on this one.
> 3. Rotor housing: the trochoid surface is coated with graphite to improve
> initial break-in.
Yes, and the area of the water jacket around the spark plugs is grooved to
increase heat transfer. IF you can get them from Mazda (out of stock most of
time), they are a decent upgrade for the older 13B's.
> 4. Eccentric shaft: the main journal diameter is increased to withstand
> higher rotating speeds, The main journal oil clearance is changed for
> 45-80u to 60-80u.
> 5. Stationary gear: a set screw type retainer is introduced to improve
> main bearing reliability.
> 6. Spacer: One of five spacers of different thicknesses is selectively
> used (marked A-E).
They changed the entire front gear and thrust washer group to withstand
higher loads. But, the FD gears can and have been used with FC parts. I
think it's a matter of clearances.
I'd like to see the service highlights; anyone have it scanned?
Mike Harrington
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org