Subject: 89-92 stock Mazda gen II turbo
From: ACRE NL
Date: 6/5/2001, 10:33 PM

mike h wrote:

It was the other way around. They went from 3 mm to 2 mm but I am not sure
what year this happened. I think it was when the 2nd gen RX7 came out with
the 13B. PL

3mm apex seals were last used in the 12A in the RX-7 (78-85). The 13B in the
last years of the 1st gen (GSL-SE) I'm pretty sure had 2mms, and I *know*
the 86-up motors all use 2mm 3-piece seals.

speaking of seals, anyone have any experiance with the Hurley Engineering
ones? I have a set to go in my 1990 single turbo motor but haven't gotten by
case of round tuits in the mail yet :)

Mike Harrington

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org