BTW, the Mazda 1993 "Service Highlights Book" PN 9999-95-045F-93 page
C-4
lists 31 engine components that are "Not interchangable" with the 91 13B
engine. Even the rotor is listed as being 'thinner'.
Major Changes are listed as-
1. Front cover:the mounting holes have been removed because of a crank
angle sensor change
2. Side housing: the side housing is thinner for decreased weight, and
the intake port has been enlarged to match the turbocharger.
3. Rotor housing: the trochoid surface is coated with graphite to
improve initial break-in.
Rob Weinstock wrote:
You can probably use this on an 89-91 13B, but if I were to do so, I would
use the 93-95 rotors and apex seals for compatibility. IIRC, the 89-91 Turbo
II rotor housings are teflon coated. You can't just use the apex seals -- I
think Mazda changed from 2mm to 3mm.
It was the other way around. They went from 3 mm to 2 mm but I am not sure
what year this happened. I think it was when the 2nd gen RX7 came out with
the 13B. PL
4. Eccentric shaft: the main journal diameter is increased to withstand
higher rotating speeds, The main journal oil clearance is changed for
45-80u to 60-80u.
5. Stationary gear: a set screw type retainer is introduced to improve
main bearing reliability.
You can replace the stationary gears and bearings as a unit. The 93-95
bearings have deeper oil grooves. By doing this, you get the nicer bearings
and the set screw retention. I just did this, and it's a bolt-in. There is
also a wide selection of main bearings, allowing the builder to blueprint
the journal-to-bearing clearance.
6. Spacer: One of five spacers of different thicknesses is selectively
used (marked A-E).
There would be no interest in replacing the spacer, but the 93-95 Torrington
thrust bearings are larger in OD. To use these, the front stationary gear,
front counterweight, thrust bearings, plates, and spacers must all be
changed to 93-95 parts. The spacer has a larger OD to center the larger ID
of the Torrington bearing. Note that the part numbers do not have the
thickness codes on them. In my case, the "A" spacer left no endplay; the "C"
spacer left 0.0025" endplay; and the "E" spacer left 0.005" endplay. Spec is
0.0016" to 0.0028".
Regards,
Rob
Yes. Perry Mick's engine being rebuilt by Mazdatrix as we speak is also using
this upgrade to get the 93 and latter larger thrust bearings. Also I might add if
you do this on the earlier engines with heavier rotors the engine needs to
be re balanced. Mazdatrix charges $190 for the re balance.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org