Subject: 89-92 stock Mazda gen II turbo
From: ACRE NL
Date: 6/5/2001, 1:51 PM



Looks like the 89-92 turbo's will fit the later engines. A combination made
in
heaven.

Paul Lamar

mike h wrote:

I meant to chime in on this earlier, but the internal dimensions of all 13B
designated motors (13B and 13BREW in this case) are the same... this means
rotor width, bearing width, and e-shaft length. So, all 13B's share the same
*geometrically* same eshaft, and thus, intermediate housing thickness.
Different model years have different features, such as the oil bypass pellet
in the front of the Eshaft, oil jet size, intermediate housing mounting
points (an important difference between 2nd gen RX7 13B and 3rd gen 13BREW
motors) and fittings (for example the EGR fitting on the 86-88 NA
intermediate housing, where there is none on the 89-91 housings).

So theoretically, you can use any manifold for a 13B on any 13B derived
motor. Where this falls apart is the difference between 6-port and 4-port
housings, and various emissions and coolant openings through the years. But,
with a welder, anything fits :)

Mike Harrington
list newbie 

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org