Subject: 89-92 stock Mazda gen II turbo
From: ACRE NL
Date: 6/5/2001, 1:54 PM


John Slade wrote:

Great, but this unit wont fit on my '93 REW engine. Or will it?

John Slade, Cozy MKIV #757, progress: http://kgarden.com/cozy
West Palm Beach, FL

marc wiese wrote:

Better check this out first. I think the 93+ has a thinner center housing
which may screw up the mounting of the ports. I seem to remember that as a
BIG difference in the 3rd gen FD.


You have third gen's John & Marc. What is the width of the center housing?
Anybody have a 2nd gen center housing they can measure for me?
I don't have one right here in my office.

Paul Lamar


marc wiese wrote:

I guess  I should have just measured it in my first message, I sold most of
my 2nd gen stuff, so can't do that one. In any case the center housing in
the 13Brewtt 93+ style engines is approx 1-31/32" thick.

1-31/32 = 1.9688 = 50.007 mm


BTW, the Mazda 1993 "Service Highlights Book" PN 9999-95-045F-93 page C-4
lists 31 engine components that are "Not interchangable" with the 91 13B
engine. Even the rotor is listed as being 'thinner'.
Major Changes are listed as-

1. Front cover:the mounting holes have been removed because of a crank
angle sensor change

2. Side housing: the side housing is thinner for decreased weight, and the
intake port has been enlarged to match the turbocharger.

3. Rotor housing: the trochoid surface is coated with graphite to improve
initial break-in.

4. Eccentric shaft: the main journal diameter is increased to withstand
higher rotating speeds, The main journal oil clearance is changed for
45-80u to 60-80u.

5. Stationary gear: a set screw type retainer is introduced to improve main
bearing reliability.

6. Spacer: One of five spacers of different thicknesses is selectively used
(marked A-E).

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org