Subject: Bell shaped oil duct
From: ACRE NL
Date: 6/7/2001, 9:26 PM

Finn Lassen wrote:

Well, I installed a bell shaped duct in my oil duct. First attempt gave
worse performance than without it. I then increased the opening near the
intake so I now have an almost straight line from 2 1/4" at intake to
zero at the end of the oil cooler. I need to do some test flights, but I
didn't see any spectacular improvement from when I had the bow-like
plenum underneath the cooler.

For those of you who have excellent air flow though the oil cooler, what
kind of [oil] temperature drop do you see across the cooler? Seems I currently
have about 20C (36 F). During this evening's flight I saw 117C [243 F] oil pan
temp and 97C [206 F] after oil cooler. Guess I need to increase my inlet opening
from 2 1/4" x 4"? My oil hoses are rated at 250F, so I'd really like to
keep oil pan temps below 120C [248 F].

Finn

Perry here, I used to measure temp in the pan but haven't for
some time now.  My oil temp going into the engine goes up to 210F,
sometimes even 220F, but I think that is marginal.
Perry Mick

Paul here. Perry is here to replace his overhauled engine in his
Long-EZ. 

What does your cowl air outlet look like Finn?
Do you have a nice radius on the oil cooler opening?
Have you used a water manometer to measure the air pressure in
the duct compared to dynamic pressure?

Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org