Subject: My turbo exhaust pipe.
From: ACRE NL
Date: 6/7/2001, 2:39 PM

Seems like every time I make something I figure out how to
make it better the next time. Looks like I need to make at least
three parts before I am entirely satisfied with the results.
This pipe was made from a burns Stainless 180 degree bend
in .049 304 SS. Next time it will be two 90 degree bends welded
together or bent up as one piece. When bends are made the material 
thins out and distorts. It then becomes hard to weld in a straight 
pieces half way in the middle of a 180 degree bend.

This is 2.5 inch in diameter and if the back cover of
the turbo charger were bored out slightly 2.75 inch diameter
pipe could be used for slightly less back pressure and
more of a PT6 turbine look :-) Also if you screw up
on the first go around :-)

BTW You may notice I did not use a separate flange on this
to save weight. I welded the tube directly to the turbo charger back 
cover. The studs that normally hold on the exhaust flange
will have to be shortened as a result.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

exhaust-pipe-turbo.jpg