Subject: My turbo exhaust pipe.
From: ACRE NL
Date: 6/7/2001, 4:07 PM

John Slade wrote:

This pipe was made from a burns Stainless 180 degree bend
in .049 304 SS. Next time it will be two 90 degree bends welded

Pity you didn't build a pusher, Paul. The exhaust from my turbo will go
straight out the back. No bends needed. Buly suggests a heat shield around
the turbo which goes into a large diameter outlet pipe and doubles as an
augmenter. Less draggy than a J pipe out the side, but will the exhaust be
cooled enough to save the prop?

John Slade, Cozy MKIV #757, progress: http://kgarden.com/cozy
West Palm Beach, FL

Yes on the straight back and I don't know about the pusher prop.
You need to ask Greg that question.

Another neat thing about the stock turbo is there are all these
stock formed sheet metal heat shields for it. Did you get those
when you got the turbo? The stock heat shields are shown in
this picture of the Mecanair turbo Mazda aircraft engine.
I remembered to ask for these when I got my turbo in Sydney.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Swiss-Mazda-p11_1.jpg