Subject: Bell shaped oil duct
From: ACRE NL
Date: 6/8/2001, 11:23 AM


Finn Lassen wrote:

Well, I installed a bell shaped duct in my oil duct. First attempt gave
worse performance than without it. I then increased the opening near the
intake so I now have an almost straight line from 2 1/4" at intake to
zero at the end of the oil cooler. I need to do some test flights, but I
didn't see any spectacular improvement from when I had the bow-like
plenum underneath the cooler.

For those of you who have excellent air flow though the oil cooler, what
kind of [oil] temperature drop do you see across the cooler? Seems I currently
have about 20C (36 F). During this evening's flight I saw 117C [243 F] oil pan
temp and 97C [206 F] after oil cooler. Guess I need to increase my inlet opening
from 2 1/4" x 4"? My oil hoses are rated at 250F, so I'd really like to
keep oil pan temps below 120C [248 F].

Finn

Perry here, I used to measure temp in the pan but haven't for
some time now.  My oil temp going into the engine goes up to 210F,
sometimes even 220F, but I think that is marginal.
Perry Mick

Paul here. Perry is here to replace his overhauled engine in his
Long-EZ.

What does your cowl air outlet look like Finn?
Do you have a nice radius on the oil cooler opening?
Have you used a water manometer to measure the air pressure in
the duct compared to dynamic pressure?

Paul Lamar


I haven't done any work on the outlets at all, yet. And no, I haven't tested the flow
through the oil cooler, not even with a hand, as Tracy suggested. I had somehow hoped
that making the input duct bell shaped, I'd see a marked cooling improvement.

What do you mean by a nice radius? On the inlet opening? Nothing changed there.

Finn

Well you need somewhere between 1/2 inch and 1 inch radius on the inlet
lips. You will need to pay strict attention to the outlets as if the
air cannot get out easily the largest inlet hole in the world will not work.

The outlet area should be streamlined and at least 120 to 150% of the 
total inlet area. Ed Anderson has louvers all over his cowl so what works
for him may not work for others. Not to mention the drag on Ed's airplane.

Paul Lamar

BTW we are shutting down for a few days to install Perry's engine in his
Long-EZ out in Palm Springs.

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org