Finn Lassen wrote:
Well, I installed a bell shaped duct in my oil duct. First attempt gave
worse performance than without it. I then increased the opening near the
intake so I now have an almost straight line from 2 1/4" at intake to
zero at the end of the oil cooler. I need to do some test flights, but I
didn't see any spectacular improvement from when I had the bow-like
plenum underneath the cooler.
For those of you who have excellent air flow though the oil cooler, what
kind of [oil] temperature drop do you see across the cooler? Seems I
currently
have about 20C (36 F). During this evening's flight I saw 117C [243 F]
oil pan
temp and 97C [206 F] after oil cooler. Guess I need to increase my inlet
opening
from 2 1/4" x 4"? My oil hoses are rated at 250F, so I'd really like to
keep oil pan temps below 120C [248 F].
Finn,
I have a 2.5" X10" (25 SQ inches) opening for my oil cooler. Also 24 sq
inch for each radiator. I think your 9 sq inch opening may be a little on
the small size. My oil temp is generally between 175-195F in flight
(depends on OAT), it will on a hot day get up to 210F on a long full power
climbout. My temp is measured after the oil cooler. Attached photo shows
all the cooling [inlet] openings on my cowling.
Ed Anderson
To make this relevant Ed we need some pictures of
the sides and bottom of your cowl showing the outlet louvers
and openings.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org