Subject: 89-92 stock Mazda gen II intercooler
From: ACRE NL
Date: 6/13/2001, 12:04 PM

mike h wrote:

In terms of size, it would seem your least $$$ route would be use the stock
IC but have different end-tanks welded on. Most rad shops, and probably you
yourself, can handle this - it's just like welding a radiator.

After that, I would look for 626 turbo IC's and/or Ford turbo-coupe T-bird
ICs, both about that size. You'd be amazed what pops up when you look up
intercooler on Ebay :)

The starion unit is a thinner core (so it won't interfere as much with a
radiator behind it, like in my application, but has a frontal area of about
12x20, IIRC. I got mine for $30 :)
Mike Harrington

Well I looked at the stock unit and it appears to be both crimped
and furnace brazed. Furnace brazing happens at 1100 F so if you try
to tig weld near it you could melt the braze and cause a leak.
Also the braze material might contaminate the tig welding.
It would be possible perhaps to tig weld near the furnace brazed
joint but the big questions is; how near?

By the way I think the T-Bird Super Coupe was supercharged and not a turbo.

Paul Lamar


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org