Subject: 89-92 stock Mazda gen II intercooler
From: ACRE NL
Date: 6/13/2001, 9:13 PM


<<        mike h wrote:
 >         >
 >         > In terms of size, it would seem your least $$$ route would be use
 > the stock
 >         > IC but have different end-tanks welded on. Most rad shops, and
 > probably you
 >         > yourself, can handle this - it's just like welding a radiator.
 >         >
 >         > After that, I would look for 626 turbo IC's and/or Ford
 > turbo-coupe T-bird
 >         > ICs, both about that size. You'd be amazed what pops up when you
 > look up
 >         > intercooler on Ebay :)
 >         >
 >         > The starion unit is a thinner core (so it won't interfere as much
 > with a
 >         > radiator behind it, like in my application, but has a frontal
area
 > of about
 >         > 12x20, IIRC. I got mine for $30 :)
 >         > Mike Harrington


 >         Well I looked at the stock unit and it appears to be both crimped
 >         and furnace brazed. Furnace brazing happens at 1100 F so if you try
 >         to tig weld near it you could melt the braze and cause a leak.
 >         Also the braze material might contaminate the tig welding.
 >         It would be possible perhaps to tig weld near the furnace brazed
 >         joint but the big questions is; how near?

 >         Paul Lamar


You can tig weld very close to factory seams. Just clamp a wet (expendable)
shop rag over the brazed seam while welding nearby. Lynn E. Hanover


Thanks Lynn I will give it a try.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org