Subject: 89-92 stock Mazda gen II intercooler
From: ACRE NL
Date: 6/13/2001, 1:57 PM


        mike h wrote:
        >
        > In terms of size, it would seem your least $$$ route would be use
the stock
        > IC but have different end-tanks welded on. Most rad shops, and
probably you
        > yourself, can handle this - it's just like welding a radiator.
        >
        > After that, I would look for 626 turbo IC's and/or Ford
turbo-coupe T-bird
        > ICs, both about that size. You'd be amazed what pops up when you
look up
        > intercooler on Ebay :)
        >
        > The starion unit is a thinner core (so it won't interfere as much
with a
        > radiator behind it, like in my application, but has a frontal area
of about
        > 12x20, IIRC. I got mine for $30 :)
        > Mike Harrington


        Well I looked at the stock unit and it appears to be both crimped
        and furnace brazed. Furnace brazing happens at 1100 F so if you try
        to tig weld near it you could melt the braze and cause a leak.
        Also the braze material might contaminate the tig welding.
        It would be possible perhaps to tig weld near the furnace brazed
        joint but the big questions is; how near?

        By the way I think the T-Bird Super Coupe was supercharged and not a
turbo.

        Paul Lamar

"Tami, John E" wrote:

Paul, in the early eighties there was a version of the T-Bird with the 4
cylinder Turbo Engine, similar to what was also offered in the Merkur 4ti
and the Mustang Turbo around the same time.

The T-Bird SC was a V6 90's model.......


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org