Back in August of last year I contacted Ron Davis for a custom
rad that looked like this. At the time he claimed he had the same idea
and was in the process of patenting it. When I was in Phoenix earlier
this week I visited Ron and asked him where my rad was. He told me
he received a patent and had built and supplied several to Nascar
racers and they worked great. I confirmed my order so hopefully
I will have my custom rad in a month or so.
This is what is called a cross counter flow rad. The rule of
thumb with rads of finite thickness is the first half of
the rad does 3/4's of the work as the difference in the air
temp and the water temp becomes nearly equal as the air flows
through the rad from front to back and absorbs heat. It takes
a considerable difference in air temp and water temp or there
is no heat transfer.
This design addresses that issue. The hot water is first passed through
the back half of the rad and then through the front half in a two
pass configuration. This maximizes the temperature difference thorough
out the rad. The trick here is the front and back half's of the
rad are thermally isolated from each other by minimizing the
metal conduction paths. To not do this defeats the intent of
the cross counter flow design.
There is no weight penalty or pressure drop penalty in either the air
flow or the water flow with this design. The cost is only slightly more
as the same number of fins and tubes are used. In theory a slighly
smaller rad (less cooling drag) could do the same cooling job.
Paul Lamar
Jerry Hey wrote:
Looks like a real break through. Simple and effective. How do I
get hold of Ron? Jerry
Ron Davis Racing Products
7334 N 108th Ave Glendale AZ 85307
1 800 842 5166
Ron also has an Aluminum radiator fill neck for $21
part number 8601 and a Stant Racing Cap for $15.75 part number
8603.
BTW one of the main reasons I wanted a two pass rad was to get the inlet
and outlet on the same end :-)
Paul Lamar
"Ray Richardson Jr." wrote:
Dear Rotary users;
Powersport also tried the crossflow rad. from Ron Davis
Very good workmanship, we used it all of last year.
Our cooling problems we experenced were more of inlet
duct design. However over the winter months we tested
coolant flows. The crossflow design had reduced our
coolant flows to 31 GPM. We had Ron Davis build a
non crossflow and now have 51 GPM. So if anyone
wants a crossflow we would be happy to sell them the
one we removed from our RV-6A.
Ray Richardson Jr.
www.powersportaviation.com--
I thought I would wake you up with that message :-)
What do you mean by "cross flow"?
If it was the rad I saw at Oshkosh on your airplane last August it was not a
cross counter flow radiator. Besides it has only been recently that
Ron Davis manufactured these as I understand what Ron Davis himself
said to me yesterday. It sure was not my design as I only drew
that in August of last year after Oshkosh and sent it to Ron Davis.
I think you are mistaken about that. Here is a picture I took of your
airplane last year. This is not a cross counter flow
radiator. It is a conventional side by side two pass radiator.
I do agree that a two pass radiator will indeed reduce your
coolant flow. No doubt about it. The question is: how much
does that affect the cooling going from 51 GPH to 31 GPH?
Got any temperature numbers on that?
BTW how is your airplane cooling these days? Got any pictures
of the new cooling layout or do we have to wait for OSH? :-)
How come you did not make it to Sun & Fun Ray?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org