I need a bit more room under the flywheel end of the engine
for my radiator so I decided to build an aluminum oil pan.
Here is my first design. It will also save a bit of
weight over the stock .050 thick steel pan at five pounds.
The aluminum pan should save about three pounds.
It is designed to have the rear
motor mount tig welded to the back panel and that is why
the back panel is specified as .125 inches thick. Also a drain
plug fitting can be welded back there as well as the oil
level sensor. It is also designed to use the stock
oil pump pick up tube and screen assembly. The rest of
the pan is .065 thick to ease the welding chore but if I find
someone that is real good at welding aluminum this could
be reduced to .049 or .050 to save a bit more weight.
BTW this design will not work with the stock 2nd gen
motor mounts. It is designed for other type motor mounts
such as my PSRU/motor-mount-adapter-plate or the
sandwich plate idea that Tracy Crook used.
As shown it needs some hand finishing such as large
holes drilled in the top so the oil can get down in
it and for the oil pick up tube.
Also of course the holes for the pan bolts.
I did it like this to cut the cost as most
people can handle these finishing type chores no problem.
The pan alone holds about four quarts of oil.
I may have found some one to make these at reasonable cost
so if you are interested let me know. You will deal direct.
The pans will be more or less custom welded so minor modifications
are possible. If so we will need sketches or drawings.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org