Well I looked at the stock unit and it appears to be both crimped
and furnace brazed. Furnace brazing happens at 1100 F so if you try
to tig weld near it you could melt the braze and cause a leak.
Also the braze material might contaminate the tig welding.
It would be possible perhaps to tig weld near the furnace brazed
joint but the big questions is; how near?
Paul Lamar
Cliff Manzke wrote:
About the furnace brazing and TIG welding: I'm not a furnace braze expert
but I think you'll be ok to TIG weld to an already brazed structure.
Aren't
aluminum radiators done this way (welding header tanks to the brazed
core)?
I'm pretty sure that during the brazing process the parent material
dilutes
the molten brazing alloy somewhat and thus changing its properties. The
brazing alloy melts at 1070?F to 1080?F the first time, but that doesn't
mean it will re-melt at that temperature.
On a related subject, I have TIG welded thin aluminum (6061) with alloy
4047
rod, which is the same as 718 and/or BAISi-4 alloys. 718 is a standard
brazing alloy and has a melting range of 1070?F to 1080?F. Compare this
to
alloy 4043 which has a melting range of 1065?F to 1170?F. It is the
narrow
"plastic" range of 4047 (only 10?F) that makes it nice to use as a welding
rod for thin sheet. Alloy 4043 is the standard for TIG welding aluminum
and
according to ESAB (the Heliarc people) "Alloys 4043 and 4047 are
considered
the same for properties per AWS D1.2 Structural Welding Code."
So you might want to try 4047 rod.....
On a side note, anybody doing any welding (aluminum or otherwise) should
get
a copy of ESAB's "Welding and Cutting Products Catalog." Lots of good
info
on welding the different alloys, which rod to use, which tungsten
electrodes
are good for what, etc, etc. It's where I got the 4047 rod trick for
welding thin sheet.
Cliff Manzke
Lucky me I just bought some 3/32 and 1/16 4043 welding rod. Thanks for the
tips
Cliff. What is the phone number for ESAB?
I don't suppose you remember the guys name that did the dynamic
balance job on Linden's three rotor ducted fan Prescot Pusher now
stored out in a hangar at Ramona do you?
Paul Lamar
ESAB's phone number is 1-800-ESAB-123. This should point you to the nearest
ESAB dealer. Or try www.esab.com.
Can't help you on the balancing job. I was never involved with that
project. Scott Duffy in the guy that would know. Maybe Jeff Spitzer can
pass the word along, since he is Scott's boss......
Cliff Manzke
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org