Subject: Ian Oil Temps pict 2
From: ACRE NL
Date: 6/15/2001, 9:05 AM


Ian & Irene Beadle wrote:

I finally put a thermocouple on the outlet of my RV6A oil cooler.
The temperature drop across the cooler varies a bit with inlet temp.
but
is around 30 degrees C. The sump temperature gets up to 115C on climb at
1000 ft/min. Ambient 25 C. The water stays around 80 to 90. I haven't
done
any high power runs yet but indications are that this is one quick
aeroplane. I am swinging a 72"X81" propeller. 2.85 drive. RPM at start
of
ground run 5800.
I have sent some more information on the mixture indicator. The
components added to the input area are a clamp I found necessary to
protect
the IC.
Ian Beadle
beadles@webace.com.au

115 C is 239 F

Looks like Ian needs those teflon encapsulated silicon oil O-rings.

Paul Lamar


Ian & Irene Beadle wrote:

Paul. 115C (239 F) in the sump corresponds to 85C (185 F )oil feed to
engine from cooler.
Tracy reconds that max. at this point is 100C (212 F).
Ian.

85C (185 F) is still a bit high for cool oil out of the cooler IMHO. Are
you using
synthetic oil in the sump?  25C (75 F) ambient is a bit low for the desert
which it looks like. You do live in the outback don't you?

Is the blue scoop the oil cooler intake or air for the engine?

Paul Lamar

Ian & Irene Beadle wrote:

The blue scoop is experimental  air to the oil cooler. It is 3" in diameter.
Air to the engine is via a large NACA vent on the port side up top.(I copied
a fuel injected Lycoming RV6A.) I live in Perth Western Australia and fly
from a farm just north. It is winter here now. Temps get to the mid 30's in
the summer.
Ian

Mid 30's is more like it. About 95 F. That is when the steam hits the air stream :-)
Three inches is a bit small but it is in an ideal location. Perhaps four or five
inches diameter would be better.  It also needs about a 1/2 or a one inch radius 
on the intake lip. That would make it near perfect with a bell shaped diffuser
where the hose feeds in. Ed Anderson had something like this at one time.
Worked pretty good but he never implemented the bell shaped diffuser part.

What do your cowl air outlets look like.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org