Subject: Ian Oil Temps pict 2
From: ACRE NL
Date: 6/15/2001, 5:42 AM


Ian & Irene Beadle wrote:

I finally put a thermocouple on the outlet of my RV6A oil cooler.
The temperature drop across the cooler varies a bit with inlet temp. but
is around 30 degrees C. The sump temperature gets up to 115C on climb at
1000 ft/min. Ambient 25 C. The water stays around 80 to 90. I haven't done
any high power runs yet but indications are that this is one quick
aeroplane. I am swinging a 72"X81" propeller. 2.85 drive. RPM at start of
ground run 5800.
I have sent some more information on the mixture indicator. The
components added to the input area are a clamp I found necessary to protect
the IC.
Ian Beadle
beadles@webace.com.au

115 C is 239 F

Looks like Ian needs those teflon encapsulated silicon oil O-rings.

Paul Lamar

Ian & Irene Beadle wrote:

Paul. 115C (239 F) in the sump corresponds to 85C (185 F )oil feed to engine from cooler.
Tracy reconds that max. at this point is 100C (212 F).
Ian.

85C (185 F) is still a bit high for cool oil out of the cooler IMHO. Are you using
synthetic oil in the sump?  25C (75 F) ambient is a bit low for the desert
which it looks like. You do live in the outback don't you?

Is the blue scoop the oil cooler intake or air for the engine?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org