Subject: RB 900 HP 3 rotor cooling and apex seal springs
From: ACRE NL
Date: 6/17/2001, 11:00 AM

I am just full of ideas this morning Jim :-)

Get an old junk rotor housing and weld a steel patch on the inside
of the exhaust port. Bolt two steel 1/2 inch plates on either
side and use an oil pump to pump it up to 500 psi (BMEP) or
so and use dial indicators to measure the radial rotor 
housing deflection.

I'll wager it is a bunch like .010 or more. I think it is going 
to want to go circular from the figure eight shape.

Then install hollow dowel pins everywhere and try it again.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org