"Bruce A. Frank" wrote:
Either your surplus material or my material, $60.00 per copy for the oil pan.
Bruce
BAFRANK@worldnet.att.net
OK folks Here is the guy to build your aluminum custom oil pans.
This is a quote from Bruce for the attached oil pan drawing.
You drill and cut all the holes.
You can also specify an oversize 1/4 thick top plate for a bit more
money if you would like to use the Tracy Crook sandwich style motor
mount brackets. this pan should be around two pounds saving about
three pounds over the stock five pound steel pan.
Contact Bruce directly at the above email address.
I have known Bruce for years and I can attest to his workmanship.
He is building a Ford V6 STOL and I run into him year after year at
OSH or Sun & Fun and other air shows.
Your on Bruce. I will send you my slightly modified drawing shortly with
a couple of gussets and a drain bung added. I will also send you the
undrilled drain bung to be welded onto the back cover of the pan.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org