SNIP
Second, I noticed that on take-off at the low elevation fields, which was
most of them on this trip, the RPM would be at 5200 which is normal,
then it
would drop off after 3 or 4 seconds into the takeoff roll to maybe 4700.
Isn't this an indication of cavitation at start up? Once the plane gets
rolling, the prop is able to get a decent "bite" which loads the engine down.
Regards,
Peter Militch Cozy Mark IV #740
Bill Freeman wrote:
We need to be careful about terminology. Cavitation occurs in a liquid when
the local
pressure is lowered to the point that the liquid flashes to gas. Typically
the gas bubble then moves with the flow to a nearby location where the
pressure is too high to sustain the gas and it extremely rapidly collapses,
often causing noise and damage to the system. Cavitation is impossible in a
gas such as air.
You are probably conceptually close in that it may well be that the prop is
stalled at low fwd speeds and unstalls as the fwd speed increases due to the
change in effective angle of attack. This is common in fixed pitch props
set up for high speed cruise.
Bill Freeman
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org