Industrial Metals in Burbank CA will cut and ship 1/2 plate.
Send it to me and I will use Tracy's redrive plate to mark the position
of all the little holes and bore the place where the oil seal goes.
and the final bore on the large pilot hole for the starter.
I will then send it back to you for final drilling of all the little
holes and you can match drill the starter mounting holes.

marc wiese wrote:

Paul
I too am interested in this plate. Want to do another?
Marc

Sure I will do one or two but if it starts to eat into my
time we need to find somebody to make these.
I don't suppose yours will have these pie shaped cutouts will it?

Paul Lamar

marc wiese wrote:

Paul,
All I would need is tracy's redrive holes in the plate. I will put in the
engine holes, starter etc. in, and I may change the outer config. Will you
install mm brackets on plate?
Marc

Those are easy to do Marc. Cut them on a band saw and use a hole saw
where the rubber bushings go. Then polish the holes a bit to make the
rubber busing's life easier. I speicified 2 inches wide on that drawing 
which is a bit on the narrow side so make them 2.25 inches wide.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org