Subject: Incident w/ EA This Month and chain drives.
From: ACRE NL
Date: 6/20/2001, 7:29 PM


 I just checked my Marks ME Handbook and you are
going to play hell getting
a 200 HP chain drive with a 6000 RPM input sprocket
to work. They are primarily
low RPM or low HP drives. Not both at the same time.
I know the auto people have
done it but they don't run 6000 RPM for long.
Perhaps the titanium chain
is going to help.


tim tracey wrote:

My sources are industrials and very accustomed to high
rpm's and high loads(2x, 3x strands)....being Titanium
just reduces the weight 50%(same structural integrity
for a given mass); some of the real exotic alloys even
have greatly reduced galling properties(high-strength,
milled apex seals, anyone?) I just wish, again, that
someone had thoughts on the harmonics..... oh, well.

Don't give up Tim. You could use the same type of harmonic
isolator Tracy Crook uses. Can you scan any of those industrial
chain HP rating data sheets and send them to us?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org