Subject: Incident w/ EA This Month and chain drives.
From: ACRE NL
Date: 6/20/2001, 8:15 PM


 >  I just checked my Marks ME Handbook and you are
 > going to play hell getting
 > a 200 HP chain drive with a 6000 RPM input sprocket
 > to work. They are primarily
 > low RPM or low HP drives. Not both at the same time.
 > I know the auto people have
 > done it but they don't run 6000 RPM for long.
 > Perhaps the titanium chain
 > is going to help.


tim tracey wrote:

 My sources are industrials and very accustomed to high
 rpm's and high loads(2x, 3x strands)....being Titanium
 just reduces the weight 50%(same structural integrity
 for a given mass); some of the real exotic alloys even
 have greatly reduced galling properties(high-strength,
 milled apex seals, anyone?) I just wish, again, that
 someone had thoughts on the harmonics..... oh, well.

Don't give up Tim. You could use the same type of harmonic
isolator Tracy Crook uses. Can you scan any of those industrial
chain HP rating data sheets and send them to us?

Paul Lamar

Jerry Hey wrote:

Tim and Paul,

 HiVo chain is designed to grip the sproket tighter as it climbs the
tooth due to centrifical force.  The chain we are using is rated for
7200 rpm and I would imagine there is a large safety margin in that
specification. Tomorrow,   I will give you an approximate weight of
what we hope will be a successful chain drive.  We are using a
spring dampner to start off with, similar to the marine application.
If it doesn't work out, it is one of those things that can be
changed later with a little work.--Jerry

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org