Subject: apex lube oil ratios
From: ACRE NL
Date: 6/20/2001, 8:17 AM


Ian & Irene Beadle wrote:

I had a look at a very  successful 20B race car today  that uses Redline
synthetic oil at 500:1.
snips..

Ian RV6A 13B.

IMHO he is asking for serious problems. Is it a drag racer where the
engine runs for only 8 seconds? The function of the that apex seal oil
is primarily to cool the apex seals and then lube them. If you cut
the volume you cut the cooling effect As shown in this Mazda SAE paper
chart. Also it better be Redline 2 cycle oil as not all synthetics
burn cleanly.

I add one ounce per gallon of 2 cycle oil to the tank of my wife's 1983
RX7 despite the fact the injection pump and oiling system is probably
still working. No noticeably effect on the ignition.
snips..

Paul Lamar

Ian & Irene Beadle wrote:

>From the chart at 6000rpm we need 80cc of oil per hour. Assume fuel
consumption of 40 litres or 40,000cc per hour(its a 20B) gives mix ratio of
500:1. Oops I just noticed its per bank.   I 'll pass on the message.
Ian

80 cc is about 80 X .0338 or 2.7 fluid ounces per hour or 5.4 ounces
for both rotors. At ten gallons per hour that would be a half ounce
per gallon or 256:1 but this chart is based on a 150 HP rotary probably.

Jim Medere suggest over four ounces per gallon for an engine generating
250 HP per rotor or above. The amount of oil needed is a function
of HP and RPM.

Racing Beat has a new Rotary Performance Technical Manual & Product
Catalog that incorporates most of what he has learned so far on the 
the third gen engines and the 900 HP turbo three rotor.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

sealtemp.gif