Subject: Chuck Dunlap's Recent Trip
From: ACRE NL
Date: 6/21/2001, 8:47 AM


Ken Powell wrote:

Chuck,
Hope you don't mind me adding my thoughts to why you don't seem to be
making more HP.  It's possible that your intake pipes are too long (they
look 'long' in the pictures that I have seen of your engine bay).  Seems
that others here on the newsletter have suggested that 20" seemed to work
best for 6000 - 6500 RPM; I plan to make my pipes in 2 pieces so that I can
add /subtract to the length and can experiment with lengths between 18" and
24".  Tracy, how long is your intake from the rotor housing to the plenum?

Ken Powell
kenpowell@aristotle.net


I think that might be a good call Ken. That could also explain
why it has enough torque to power the prop past stall at 4700
engine RPM.

That silly oil filler pipe and dip stick might get in the way of
optimum pipe length on a low cowl  aircraft installation. Perhaps
I can come up with a new filler pipe welded into the back of the
pan near the firewall. The dip stick can be fastened to the cap.

Paul Lamar

Judging from the photo, I would guess my intake runners are about 6 inches
shorter than Chucks.  Don't want to restart an  old debate but I must point
out that a plenum chamber is not the same as a dynamic chamber which is what
I am using.

My rpm readings are as follows:

static -  5100        (I never notice any stall indication)
climb at 120mph  - 5350    (best point to compare two engines with similar
props IMHO)
Max rpm in level flight - 6400  (I need more prop)

My prop is a two blade wood Performance prop 68L x  71P  Very close to what
Chuck & Ed are using I think.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org