Subject: Tailwind Cooling (try again)
From: ACRE NL
Date: 6/21/2001, 9:15 PM


 > >Jerry Hey wrote:
 >>
 >>  Paul, here is a revision of the first drawing taking into
 >>  consideration your suggestions on inlet sizing.  I moved the rad-air
 >>  exhaust up the access belly pan, by incorporating louvers.  This
 >>  would lie in the shadow of the intake structure.  I don't know if
 >>  this is good or bad.  Jerry


 >Maybe.
 >
 >At high angles of attack (slow speed climb) the bottom of the fuselage
 >in that area may not be low pressure at all.
 >
 >I am not sure that will work as well as the under the elevator trick.
 >
 >Don't worry about the air velocity inside the aft fuselage. The pressure
 >may be a bit higher than outside (when the flaps are closed)
 >but the velocity will be low (because of the
 >large cross sectional area of the aft fuselage) until it gets
 >back near the flap openings. Back there is where you need a
little sheet metal
 >guidance for the air flow. The whole idea here is to recover some of
 >the drag of
 >the scoops hanging down  under the fuselage with a little hot air
 >squirting out the back for a minor jet effect.
 >
 >Paul Lamar


 I wish the "jet effect" could be quantified.  Might be doing a lot of
 work for negligible returns. Jerry

Perhaps. The P51 designers claimed it canceled the drag of the scoop.
Some say it even added a bit of thrust because the air was heated.
I don't see how those cowl flap back there would be tough to build.
A piano hinge with flat alloy sheet should work fine.

Paul Lamar

Absolutely flush when closed,,smooth operating, stable in any
position and at any speed. A friend,who is a real craftsman, fast,
accurate, capable in every way just spent 40 hours increasing the
outlet on the cowl of his 0-320  One Design.  And that had no moving
parts. I've  heard  the claims for the P-51 jet effect but I am very
skeptical. A relatively small amount of air exiting  just a little
bit faster than a very large aircraft is traveling isn't going to
provide much boost. I doubt that the exhaust air from a P-51 is
traveling as fast as the prop wash which it would have to exceed to
generate thrust (I think).   I am a non believer by nature. It
irritates all my friends.      Jerry

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org